SkyTrak 6036 Service Manual User Manual

Page 120

Cab and Covers

4.16

Model 6036 Legacy

8. Remove three hex-head capscrews (Fig. 4-27, 1)

three lockwashers and three flat washers.

9. Remove the auxiliary hydraulics joystick assembly

(Fig. 4-27, 2) from the vehicle.

Figure 4-27 Remove the Auxiliary Hydraulics

Joystick Assembly

b. Auxiliary Hydraulics Joystick Installation

1. Route the control cable through the opening at the

bottom of the cab.

2. Secure the auxiliary hydraulics joystick assembly

(Fig. 4-27, 2) to the cab console with three hex-head
capscrews (1) three lockwashers and three flat
washers.

3. Connect the auxiliary hydraulics control cable to the

main control valve:

a. Slide the inner jam nut (Fig. 4-28, 1) over the

end of the auxiliary hydraulics control cable (2),
and install the cable in the bracket with one nut
on either side of the bracket. DO NOT tighten the
jam nuts at this time.

b. Connect the end of the cable to the shaft from

the control valve. Secure with an anchor pin and
spring pin (Fig. 4-28, 3).

c. Adjust the jam nuts until the distance (Fig. 4-28, 4)

from the outer jam nut to the end of the ferrule is
the same as recorded during removal. Tighten
the jam nuts.

Figure 4-28 Connect the Auxiliary Hydraulics Control

Cable to the Main Control Valve

4. Install the joystick access panel (Fig. 4-29, 1) and

secure using four button-head screws (2).

Figure 4-29 Install the Joystick Access Panel

MA8530

MA8490

OH2430