SkyTrak 6036 Service Manual - Manual (Page 385)

9.33 Model 6036 Legacy
Electrical System
Repair or replace
wiper harness.
Not
OK
Repair or replace
wiper harness.
Not
OK
If OK
Not
OK
Check for battery voltage at
circuit 32 (GRY/WHT) and
circuit 6 (RED/WHT)
at cab/wiper harness
connection. Check
1A (BLK) ground connection.
With front wiper switch in
LOW or HIGH position, the
wiper does not operate.
Repair or replace
wiper harness.
Check for battery voltage on
wiper switch connector at
circuit 6 (RED/WHT) and 6A
(RED/WHT).
If OK
Check 10-amp wiper fuse.
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. All connections relating
to circuit are clean and
tight.
Replace wiper switch.
Replace wiper motor.
If OK
Not
OK
Not
OK
Replace fuse.
Check circuit 4A (GRN) at
wiper motor for battery
voltage.
Move wiper switch to LOW
position and check for battery
voltage at circuit 3 (WHT).
Move wiper switch to HIGH
position and check for battery
voltage at circuit 2 (BLU).
If OK
If OK