SkyTrak 6036 Service Manual - Manual (Page 387)

9.35 Model 6036 Legacy
Electrical System
Repair or replace
wiper harness.
Not
OK
If OK
Not
OK
Check for battery voltage at
circuit 32 (GRY/WHT) and 6B
(RED/WHT) at cab/wiper
harness connection. Check
1B (BLK) ground connection.
Roof windshield wiper does
not work with switch in ON
position.
Repair or replace
cab/wiper harness.
Check circuit 6B (RED/WHT)
and 6C (RED/WHT) at the
wiper switch connection.
If OK
Check 10-amp wiper fuse.
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. All connections relating
to circuit are clean and
tight.
Replace switch.
Check for battery voltage at
circuit 9 (GRN) and 5 (YEL).
If OK
Not
OK
If OK
Replace wiper motor.