SkyTrak 6036 Service Manual - Manual (Page 60)

Boom
3.20 Model 6036 Legacy
46. Remove the grease fittings (Fig. 3-45, 1) from the
lift/lower cylinder mounts (2) and the slave cylinder
mounts (3) on the outer boom. Save the grease
fittings for reassembly.
47. Remove the self-aligning bearings (Fig. 3-45, 4) from
the lift/lower cylinder mounts (2) and the slave cylinder
mounts (3). Inspect the bearings. If the bearing rotates
freely inside the outer race, the bearing can be reused.
Figure 3-45 Remove the Lift/Lower and Slave Cylinder
Grease Fittings and Bearings
48. On the left side of the outer boom, remove the locknut
(Fig. 3-46, 1), angle indicator (2) and flat washers (3)
from the weld stud. Save the angle indicator and all
the hardware for reassembly.
Figure 3-46 Remove the Angle Indicator
3.3.4 Outer Boom Installation
IMPORTANT: Light lubrication of the boom wear surfaces
with a rust inhibitor/lubricant such as LPS 3 or equivalent
is recommended to keep the boom wear surfaces
lubricated properly. Light lubrication of the boom wear
surfaces is also recommended in salt air climates and
when the vehicle is stored, to help prevent rusting.
Note: If reassembling the existing boom assembly,
proceed to Step 3.
1. Assemble a new angle indicator decal (Fig. 3-47, 1)
to the left side of the boom assembly. Place the hole
in the decal around the weld stud (2), and align the
upper edge of the decal parallel with the top edge of
the boom assembly.
Figure 3-47 Install the Boom Angle Indicator Decal
2. Place the two flat washers (Fig. 3 -46, 3) and the
angle indicator (2) onto the weld stud. Secure in
place with the locknut (1). After tightening the
locknut, the angle indicator must pivot freely on the
weld stud. If the angle indicator binds, loosen the
locknut slightly. Recheck to be sure the angle
indicator pivots freely.
MA6520
4
1
2
3
1
4
MH1300
1
3
2
WARNING:
Wear protective footwear
with reinforced toe caps and slip-resistant
soles. Failure to comply can result in foot or
other bodily injury from crushing, slipping or
falling.
WARNING:
NEVER lift a heavy object
without the help of at least one assistant or a
suitable sling and hoist. Failure to comply can
result in death or serious personal injury.
MH1320
1
2