SkyTrak 6036 Service Manual - Manual (Page 189)

7.11 Model 6036 Legacy
Engine: Cummins 4BT3.9
9. Loosen clamps (Fig. 7 -9, 1 and 2) on the radiator
return (lower) hose (3). Work the hose off the
radiator. Inspect the hose, and replace if necessary.
Figure 7-9 Coolant System Components
10. Loosen both clamps (Fig. 7-9, 4) on the radiator
input (upper) hose (5). Work the hose off the
radiator. Inspect the hose, and replace if necessary.
11. Remove oil cooler input (Fig. 7 -9, 6) and output (7)
fittings from oil cooler (8) and cap the lines.
12. Remove the six oil cooler capscrews (Fig. 7 -9, 9),
lockwashers (10) and flat washers (11). Remove oil
cooler (8).
13. Remove transmission oil input (Fig. 7-10, 1) and
output (2) hoses from the radiator fittings (3 and 4)
and cap the lines.
Figure 7-10 Transmission Oil Hose Connections
14. Disconnect the radiator overflow tube (Fig. 7-9, 12)
from the radiator.
15. Remove the four lower radiator support bracket
capscrews (Fig. 7-9, 13), lockwashers (14) and flat
washers (15).
16. Remove the four upper radiator capscrews (Fig. 7 -9,
16), lockwashers (17) and plain washers (18).
17. Remove the radiator (Fig. 7-9, 19), shroud (20) and
side support brackets (21 and 22) from the vehicle.
18. Remove the shroud (Fig. 7-9, 20) from the radiator
(19).
19. If replacing the radiator, remove the left (Fig. 7-9,
21) and right (22) side support brackets by removing
the hex nut (24), lockwasher (23), radiator isolator
mount (25), hex-head capscrew (26) and plain
washer (27), and install on the new radiator.
MA9120
4
2 3
1
5
6
7
8
12
18
9 17
11
10
16
20
19
15
14
13
21
22
24
23
25
27
26
1
2
3
MA9130
4