SkyTrak 6036 Service Manual - Manual (Page 359)

9.7 Model 6036 Legacy
Electrical System
9.5.3 Cleaning and Drying
Clean a wire harness with a natural bristle brush and the
same detergent used to clean the vehicle. Allow the
harness to air dry. DO NOT allow surface temperatures
to exceed 300° F (149° C).
9.5.4 Inspection and Repair
Replace a harness only if it is damaged or unusable. If a
splice or repair must be made to a wire, always use rosin
core solder to bond wires together. Use heat-shrink
tubing or insulating electrical tape to cover all splices or
bare wires.
9.5.5 Installation
The wiring harnesses are held securely in place by wire
tie wraps, clips or other devices that help prevent chafing
or wearing of the insulation and entanglement with
moving parts. Sections of ribbed plastic conduit have
been installed where wiring or harnesses pass through
openings in the vehicle frame. Always install tie wraps,
clips, conduit, etc., in their original locations to help
prevent damage to the wiring or harnesses.
9.5.6 Wire Code and Color
The chart below indicates the wire code abbreviation and
color as used on the electrical schematics.
Wire Code Color
BLK Black
BLU Blue
BRN Brown
DK BLU Dark Blue
DK GRN Dark Green
GRN Green
GRY Gray
LT BLU Light Blue
LT GRN Light Green
ORG Orange
PNK Pink
PUR Purple
RED Red
TAN Tan
YEL Yellow
VIO Violet
WHT White