SkyTrak 6036 Service Manual - Manual (Page 421)

9.69 Model 6036 Legacy
Electrical System
e. Operator’s Instrument Cluster Bulb Removal
1. Disconnect the negative (-) battery cable at its
battery terminal.
2. Unscrew the plastic ring retainer from the back of the
instrument cluster. Disconnect the harness plug
connector from the back of the instrument cluster
(Fig. 9-44, 3). Remove three screws, (1) securing
the instrument cluster rear access plate (2). Remove
the cover plate.
Figure 9-44 Instrument Cluster Back Cover Removal
3. Rotate the suspect bulb assembly (Fig. 9-45, 1)
1/4 turn counterclockwise and remove bulb.
Figure 9-45 Instrument Cluster Bulb Replacement
f. Operator’s Instrument Cluster Installation
1. Install the instrument cluster rear access plate
(Fig. 9-44, 2) using three screws (1).
2. Connect the harness plug terminal into the
instrument cluster terminal (Fig. 9-44, 3).
3. Place the instrument cluster into the cutout, and
install the plastic retaining ring and secure.
4. Install the right side access panel (Fig. 9-43, 2)
using four screws (1).
5. Connect the negative (-) battery cable to the
negative battery terminal.
Operator’s Display Panel Test
Check the following, as the key switch is placed in the
RUN position (Fig. 9-46):
Figure 9-46 Ignition Key Switch Positions
1. All lights must illuminate for a minimum of 3 seconds.
Note: If the park brake switch is engaged, the park
brake instrument cluster light will also stay illuminated.
2. Alternator warning and engine oil pressure light must
stay illuminated after three seconds.
MA7930
2
1
3
MA7940
Stabil-TRAK™
(Not Used)
Park Brake
High Beam
(Optional)
Transmission
Temperature
Fuel Level
Engine
Coolant
Temperature
Alternator
Hyd. Oil
Temperature
Engine Oil
Fuel Level
Turn Signal
(Optional)
1
OT0680
OFF RUN
START