SkyTrak 6036 Service Manual - Manual (Page 191)

7.13 Model 6036 Legacy
Engine: Cummins 4BT3.9
14. Install the battery (Fig. 7 -13, 2) and battery hold-down
(5).
Figure 7-13 Battery and Cable Location
15. Connect the negative (-) grounding connector
(Fig. 7-13, 4) to the vehicle frame.
16. Connect the positive (+) (Fig. 7-13, 3) battery cable
to the battery. Connect the negative (-) battery cable
(2) to the battery.
17. Run the engine to operating temperature. Visually
check for leaks with the engine running. Check the
coolant level in the overflow bottle (Fig. 7-14, 2), and
fill, or drain, as necessary.
Figure 7-14 Fill the Radiator and Overflow Tank
18. Check hydraulic oil level at hydraulic tank. Hydraulic
oil level should be to the middle of the sight gauge.
Check oil cooler and transmission hose connections
for leaks.
c. Coolant Heater Removal
1. Level the vehicle, ground the attachment, place the
travel select lever in NEUTRAL (N), and engage the
parking brake switch and shut off the engine.
Remove the ignition key. Secure accident prevention
tags to the steering wheel and ignition switch. (Refer
to Section 1.5, “Accident Prevention Tag Usage.”
)
2. Unlock, unlatch and open the side and rear engine
access doors. Allow the engine to cool before
proceeding. Draining the cooling system while the
engine is hot can cause cracks in the engine block.
3. Disconnect the negative (-) battery cable.
MA8410
2
4
1 3
_
+
5
OA1310
1
2
WARNING:
DO NOT attempt this
procedure when the engine is hot. Wait for the
engine, muffler and tailpipes to cool down
before proceeding. Failure to do so could result
in severe burns.
WARNING:
Hot coolant can cause
severe burns or eye injury. NEVER remove the
radiator cap while the engine is hot. The
cooling system is under pressure. Wear
protective clothing and safety glasses.