HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 90)

Network configuration
You might need to configure certain network parameters on the MFP. You can configure these
parameters from installation software, the MFP control panel, the embedded Web server, or
management software, such as HP Web Jetadmin or the HP LaserJet Utility for Macintosh.
NOTE For more information about using the embedded Web server, see Using the
embedded Web server .
For more information on supported networks and network configuration tools, see the HP Jetdirect Print
Server Administrator’s Guide. The guide comes with printers in which an HP Jetdirect print server is
installed.
This section contains the following instructions for configuring network parameters from the MFP control
panel:
● Configuring TCP/IP parameters.
● Disabling unused network protocols.
Configuring TCP/IP parameters
You can use the MFP control panel to configure the following TCP/IP parameters:
● IP address (4 bytes)
● Subnet mask (4 bytes)
● Default gateway (4 bytes)
To manually configure TCP/IP parameters from the MFP control panel
Use manual configuration to set an IP address, subnet mask, and default gateway.
Setting an IP address
1. Press Menu to enter the MENUS.
2. Touch CONFIGURE DEVICE .
3. Touch I/O .
4. Touch JETDIRECT MENU .
5. Touch TCP/IP .
6. Touch CONFIG METHOD .
7. Touch MANUAL or MANUAL SETTINGS .
8. Touch IP ADDRESS .
9. Use the right and left arrows to select each byte of the IP address, and then use the numeric keypad
to enter the value of each byte.
10. Touch OK .
70 Chapter 3 I/O Configuration ENWW