HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 77)

Stapler/stacker submenu
Use the items in this menu to configure the stapling options.
To gain access to this menu, touch CONFIGURE DEVICE , and then touch STAPLER/STACKER .
NOTE This menu appears only when the stapler/stacker is installed.
Item Values Explanation
STAPLES NONE*
ONE
To enable stapling, select ONE .
NOTE Printer-driver settings
override control-panel settings.
STAPLES OUT STOP
CONTINUE*
Use this item to configure the MFP to
either stop or continue when the staple
cartridge is empty. If you select
CONTINUE, jobs are stacked in the
output bin, but they are not stapled.
Default=15
I/O submenu
Items in the I/O (input/output) submenu affect the communication between the MFP and the computer.
To gain access to this menu, touch CONFIGURE DEVICE , and then touch I/O .
Item Values Explanation
I/O TIMEOUT 5 to 300 Use this to select the I/O timeout period
in seconds. (I/O timeout refers to the
time, measured in seconds, that the MFP
waits before ending a print job.)
Use this setting to adjust timeout for best
performance. If data from other ports
appear in the middle of your print job,
increase the timeout value.
Default = 15
PARALLEL INPUT HIGH SPEED
ADVANCED FUNCTIONS
HIGH SPEED accepts faster parallel
communications used for connections
with newer computers. This item
contains NO and YES* options.
ADVANCED FUNCTIONS turns the
bidirectional parallel communication on
or off. The default is set for a bidirectional
parallel port (IEEE-1284). This setting
allows the MFP to send status readback
messages to the computer. (Turning the
parallel advanced functions on might
slow language switching.) This item
contains OFF and ON* options.
ENWW Configure device menu 57