HP Color LaserJet 4730 Multifunction Printer series User Manual
Page 293
Control panel message
Description
Recommended action
STACKER COVER OPEN
The top cover of the stacker unit is open. The
unit cannot function.
Close the top cover and resend the job.
STAPLER DOOR OPEN
The stapler module door is open. The stapler/
stacker cannot operate in this condition. The
amber light on the stapler/stacker is blinking.
Close the stapler module door.
STAPLER DOOR OPEN
The top cover of the stapler unit is open. The
unit cannot function.
Close the top cover and resend the job.
STAPLER LOW
ON STAPLES
Fewer than 20 usable staples remain in the
stapler cartridge. The status light is solid
green.
Order and install a new stapler cartridge. For
information about replacing the stapler
cartridge, see
.
STAPLES OUT
The stapler in the stapler/stacker is out of
staples. The MFP behavior depends on
how STAPLES OUT is configured in the
Output Setup submenu.
●
If STAPLES OUT=STOP, the MFP
stops printing until you refill the stapler
or touch
OK
. This is the default setting.
●
If STAPLES OUT=CONTINUE, the
MFP continues, but the job is not
stapled.
Replace the stapler cartridge. For more
information, see
.
The Digital Sending Service at
Contact administrator.
The MFP cannot communicate with the
specified IP address.
Verify the IP address. Contact the network
administrator.
The Digital Sending Service must be
upgraded to support this version of the
MFP firmware. Contact administrator.
The Digital Sending Service is not supported
by the version of the firmware that is currently
installed for the MFP.
Check the firmware version. Contact the
network administrator.
TOO MANY PAGES
IN JOB TO STAPLE
The maximum number of sheets that the
stapler can staple is 30, regardless of paper
type or weight. The print job finishes printing
but is not stapled.
Manually staple print jobs that contain more
than 30 sheets.
TOP BIN
The output bin is full. The amber light on the
stapler/stacker is blinking.
Remove paper from the output bin.
TOP DOOR OPEN
The jam access door is open. The stapler/
stacker cannot operate in this condition. The
amber light on the stapler/stacker is blinking.
Close the jam access door.
Transfer unit can
be easily damaged.
alternates with
FOR HELP TOUCH ?
The supplies gauge will display the
consumption levels of print cartridges.
The cartridge is either not installed or not
correctly installed in the MFP.
1.
Open the top and side covers and then
open the image transfer unit.
CAUTION
The image
transfer unit can be easily
damaged.
2.
Insert the print cartridge and make sure
that it is fully seated.
3.
Close the image transfer unit and then
close the top and side covers.
4.
If the error persists, contact HP support
at
TRAY X EMPTY
The specified tray is empty and the current
job does not need this tray to print.
Refill the tray at a convenient time.
ENWW
Control panel messages
273