HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 64)

Item Values Explanation
NOTE You can override any of
these settings for a particular job
by using the Copy screen.
DENSITY 0 to 8
Default=4
Specifies the contrast and brightness of
the image. You can choose from nine
increments.
0=darkest
8=lightest
Copying submenu
To gain access to this menu, touch CONFIGURE DEVICE , and then touch COPYING .
Item Values Explanation
COLOR MODE COLOR COPIES
BLACK COPIES
Indicates whether copies should be printed in color
or black-and-white.
NUMBER OF SIDES 1*
2
Indicates whether images should be printed on one
side or both sides of the copy.
COLLATE OFF
ON*
Indicates whether copies should be collated or not
collated.
PAPER DESTINATION OUTPUT BIN 1*
OUTPUT BIN 2*
OUTPUT BIN 3*
Select the output bin on the optional 3-bin mailbox.
Output Bin 1 is the default bin for copying.
Output Bin 2 is the default bin for faxing.
Output Bin 3 is the default bin for printing.
NOTE This item appears only if an
optional 3-bin mailbox is installed.
COPIES 1–999 Indicates the number of copies made when you
press
Start without selecting the number of copies
by using the numeric keypad.
STAPLE NONE*
1-EDGE
To enable stapling, select 1-EDGE.
NOTE This item is available only if the
stapler/stacker is installed.
FIRST COPY SPEED NO EARLY WARM UP*
EARLY WARM UP
Select NO EARLY WARM UP to disable the Fast
First Copy feature. Using the Fast First Copy
feature can cause excessive wear on the MFP.
This is the default setting.
Select EARLY WARM UP to enable the Fast First
Copy feature, which decreases the time that the
44 Chapter 2 Using the control panel ENWW