HP Color LaserJet 4730 Multifunction Printer series User Manual
Page 289
Control panel message
Description
Recommended action
REMOVE ALL
PRINT CARTRIDGES
To exit press
Stop
The MFP is executing a component test and
the component selected is Belt Only.
Remove all print cartridges.
Remove at least one
print cartridge.
To exit press
Stop
The MFP is executing a disable cartridge
check or component test where the
component selected is the cartridge motor.
Remove one print cartridge.
REPLACE
CARTRIDGE
The supplies gauge will display the
consumption levels of print cartridges.
alternates with
To continue touch "OK".
The supplies gauge will display the
consumption levels of print cartridges.
The identified print cartridge has reached the
end of life and the COLOR SUPPLY OUT
setting in the SYSTEM SETUP menu is set to
STOP AT LOW. Printing can continue.
1.
Order the appropriate print cartridge.
2.
To continue, touch
OK
.
3.
Open the top and side covers and then
open the image transfer unit.
CAUTION
The image
transfer unit can be easily
damaged.
4.
Remove the identified print cartridge.
5.
Install a new print cartridge.
6.
Close the image transfer unit and then
close the top and front covers.
7.
Supplies ordering information is also
available from the embedded Web
server. See
for more
information.
REPLACE FUSER KIT
For help press
The fuser kit has reached the end of its life.
Replace the fuser kit. Printing can continue
but print quality might be reduced.
1.
Open the top cover.
2.
Grasp the purple handles on the fuser
unit.
3.
Remove the old fuser unit from the MFP.
4.
Install a new fuser unit and secure with
thumb screws.
5.
Close the top cover.
6.
Supplies ordering information is also
available from the embedded Web
server. See
for more
information.
ENWW
Control panel messages
269