HP Color LaserJet 4730 Multifunction Printer series User Manual
Page 288
Control panel message
Description
Recommended action
alternates with
Ready
NOTE
This will also delete any files
saved in RAM.
RAM DISK DEVICE
FAILURE
To clear touch "OK".
alternates with
Ready
A device failure has occurred on the specified
drive.
1.
To clear the message, touch
OK
.
2.
If the message persists, turn the MFP off
then on.
3.
If the message still persists, contact HP
Support at
RAM DISK FILE
OPERATION FAILED
To clear touch "OK".
alternates with
Ready
The MFP received a PJL file system
command that attempted to perform an
illogical operation (for example, to download
a file to a non-existent directory).
Printing may continue.
1.
To clear the message, touch
OK
.
2.
If the message persists, turn the MFP off
then on.
3.
If the message reappears, there may be
a problem with the software application.
RAM DISK IS
WRITE PROTECTED
To clear touch "OK".
alternates with
Ready
The file system device is protected and no
new files can be written to it.
1.
To enable writing to the RAM disk, turn
off write protection, using HP Web
Jetadmin software.
2.
To clear the message, touch
OK
.
3.
If the message persists, turn the MFP off
then on.
Ready
The supplies gauge will display the
consumption levels of print cartridges.
The MFP is online and ready for data. No
status or device attendance messages are
pending at the display.
No action necessary.
Ready
Diagnostics mode
To exit press
Stop
The MFP is in a special diagnostics mode.
Press the
Stop
key to exit the special
diagnostics mode.
OR
No action is necessary.
Ready
IP ADDRESS
The MFP is online and ready.
No action necessary.
REATTACH OUTPUT BIN
The standard output bin was detached when
the MFP was turned on, or the cable on the
stapler/stacker or the 3–bin mailbox is not
connected to the MFP.
Turn the MFP off. If you are using the stapler/
stacker or the 3–bin mailbox, make sure that
the cable is connected to the MFP. Reattach
the output bin, and then turn the MFP on.
Observe the LED on the output device. If it is
flashing or amber,
lights for the 3-bin mailbox and stapler/
stacker
.
Receiving
upgrade
A firmware upgrade is in progress.
Do not turn the MFP off until the MFP returns
to Ready.
REINSTALL OUTPUT DEVICE
The output device has been removed or is not
attached.
Make sure the output bin, 3–bin mailbox, or
stapler/stacker is correctly installed on the
MFP.
268
Chapter 12 Solving problems
ENWW