HP Color LaserJet 4730 Multifunction Printer series - Manual (Page 281)

Control panel message Description Recommended action
INCORRECT SUPPLIES
For status touch "OK".
The supplies gauge will display the
consumption levels of print cartridges.
At least one supply item is incorrectly
positioned in the MFP and another supply
item is missing, incorrectly placed, out, or low. 1. Touch OK to access the SUPPLIES
STATUS menu.
2. Use the scroll bar to highlight the
specific supply that has a problem.
3. Press to view help for the supply.
4. Use the scroll bar to step through the
instructions.
Initializing
permanent storage
Displayed when the MFP is turned on to show
that permanent storage is being initialized. No action necessary.
Initializing... This message is displayed when the MFP is
turned on, as soon as the individual tasks
begin initialization. No action necessary.
INSERT OR CLOSE
TRAY X
For help press
Tray X must be inserted or closed before the
current job can be printed. Close the tray indicated.
INSTALL FUSER The fuser is not installed or is not installed
correctly. 1. Confirm that the fuser is installed in the
MFP and is fully seated.
2. Use the scroll bar to step through the
instructions.
INSTALL SUPPLIES
For status touch "OK".
The supplies gauge will display the
consumption levels of print cartridges.
At least one supply item is missing or is not
correctly seated in the MFP and another
supply item is missing, incorrectly placed,
out, or low. Insert the supply item or make
sure the installed supply item is fully seated. 1. Press Menu to access the SUPPLIES
STATUS menu.
2. Touch INFORMATION.
3. Use the scroll bar to highlight the
specific supply that has a problem.
4. Press to view help for the supply.
5. Use the scroll bar to step through the
instructions.
INSTALL TRANSFER UNIT The transfer unit is not installed or is not
installed correctly. 1. Use the scroll bar to access the
SUPPLIES STATUS menu.
2. Scroll to and select the transfer unit.
3. Press to view help.
4. Use the scroll bar to step through the
instructions.
INSUFFICIENT MEMORY
TO LOAD FONTS/DATA
For help press
alternates with
Device
To continue touch "OK".
The device does not have enough memory to
load the data, such as fonts or macros from
the location specified. Device can be one of
the following:
INTERNAL = ROM directly on the formatter
board
CARD SLOT X = font card in slot X
DIMMS
1. To use the device without the data,
touch
OK .
2. To solve the problem, add more
memory to the device. DDR SDRAM
Memory: 128MB, (Q2630A) or 256MB
(Q2631A).
ENWW Control panel messages 261