HP Color LaserJet 4730 Multifunction Printer series User Manual
Page 340
The printer name, IP address, or Rendezvous host name does not appear in the printer list in the Print Center or Printer Setup
Utility.
Cause
Solution
The printer might not be ready.
Make sure that the cables are connected correctly, the printer is on,
and the ready light is on. If you are connecting through a USB or
Ethernet hub, try connecting directly to the computer or use a different
port.
The wrong connection type might be selected.
Make sure that USB, IP Printing, or Rendezvous is selected,
depending on the type of connection that exists between the printer
and the computer.
The wrong printer name, IP address, or Rendezvous host name is
being used.
Print a configuration page in order to check the printer name, IP
address, or Rendezvous host name. Verify that the name, IP address,
or Rendezvous host name on the configuration page matches the
printer name, IP address, or Rendezvous host name in the Print
Center or Printer Setup Utility.
The interface cable might be defective or of poor quality.
Replace the interface cable. Make sure to use a high-quality cable.
The printer driver does not automatically set up your selected printer in the Print Center or Printer Setup Utility.
Cause
Solution
The printer might not be ready.
Make sure that the cables are connected correctly, the printer is on,
and the ready light is on. If you are connecting through a USB or
Ethernet hub, try connecting directly to the computer or use a different
port.
The printer software might not have been installed or was installed
incorrectly.
Make sure that the printer PPD is in the following hard-drive folder:
Library/Printers/PPDs/Contents/Resources/
the language that you are using. If necessary, reinstall the software.
See the getting started guide for instructions.
The Postscript Printer Description (PPD) file is corrupt.
Delete the PPD file from the following hard-drive folder: Library/
Printers/PPDs/Contents/Resources/
where
you are using. Reinstall the software. See the getting started guide
for instructions.
The printer might not be ready.
Make sure that the cables are connected correctly, the printer is on,
and the ready light is on. If you are connecting through a USB or
Ethernet hub, try connecting directly to the computer or use a different
port.
The interface cable might be defective or of poor quality.
Replace the interface cable. Make sure to use a high-quality cable.
A print job was not sent to the printer that you wanted.
Cause
Solution
The print queue might be stopped.
Restart the print queue. Open print monitor and select Start Jobs.
The wrong printer name or IP address is being used. Another printer
with the same or similar name, IP address, or Rendezvous host name
might have received your print job.
Print a configuration page in order to check the printer name, IP
address, or Rendezvous host name. Verify that the name, IP address,
or Rendezvous host name on the configuration page matches the
Table 12-9
Problems with Mac OS X (continued)
320
Chapter 12 Solving problems
ENWW