HP XP RAID Manager Software - Manual (Page 78)

78 HP StorageWorks Disk Array XP RAID Manager: User’s Guide
$HORCM_TRCBUF
Specifies the RM trace mode. If you specify this
environment variable, data is written to the trace file in
nonbuffered mode. If you do not specify it, data is
written in buffered mode.
The trace mode of RM can be changed in real time by
using the horcctl –c –b command.
$HORCM_TRCUENV
Specifies whether to use the trace control parameters
(TRCLVL and TRCBUF trace types) as they are when a
command is issued. When you specify this environment
variable, the most recently set trace control parameters
are used. If you do not specify it, the default trace
control parameters are used: tracing becomes level 4,
and trace mode is set to buffer mode.
$HORCM_FCTBL
Changes the fibre address conversion table number
when the target ID indicated by the raidscan command
is different from the target ID used by the host.
$HORCMSTART_WAIT
Changes the timeout value (in seconds) for RM startup.
The default is 200.
RM command environment variables
When issued, CA commands use these environment variables:
$HORCC_LOG Specifies a command log directory name. If this
variable is not specified, the following directory is
used:
/HORCM/logn
(n is the instance number)