HP XP RAID Manager Software - Manual (Page 112)

112 HP StorageWorks Disk Array XP RAID Manager: User’s Guide
Specifying a negative value cancels the trace mode. A
negative value n is specified as –
–n , where n is any
digit between 1 and 9. For example:
horcctl –l – –4
Level 4 is the default setting and must not be changed
unless directed by an HP service representative.
Setting a trace level to other than 4 can impact problem
resolution if a program failure occurs.
Levels 0 to 3 are for troubleshooting.
When a change option to the trace control parameter is
specified, a warning message is displayed, and the
command enters interactive mode.
–q Terminates interactive mode and exits this command.
–s size(KB) Changes the default trace buffer size, which is 1 MB, in
units of 1,024 bytes.
–t type Sets a trace type to the one specified in type. When
specified, only traces of the specified type are output. A
value between 0 and 511 can be specified. One or more
values can be specified.
–z (Not for use with MPE/iX) This option makes this
command (horcctl) enter interactive mode.
–zx (Not for use with MPE/iX or OpenVMS) This option
prevents prevents the use of RM in interactive mode.
–S Shuts down RM.
–D Displays the command device name currently used by
RM.
If the command device is blocked due to online
maintenance (microprogram replacement) of the disk