HP XP RAID Manager Software - Manual (Page 171)

171
This option is effective without specification of the
–g group option.
If the specified raw_device is listed in multiple device
groups, this applies to the first one encountered.
–d [g] seq# LDEV# [MU#]
Searches the RM instance configuration file (local
instance) for a volume that matches the specified
sequence # and LDEV. If a volume is found, the
command is executed on the paired logical volume
(–d) or group (–dg).
This option is effective without specification of the
–g group option.
If the specified LDEV is listed in multiple device
groups, this applies to the first one encountered.
seq # LDEV # can be specified in hexadecimal (by the
addition of 0x) or decimal format.
–FCA [MU#] Used to resync a CA P-VOL that is also a BC P-VOL.
If the –l option is specified, this option resynchronizes a
cascading CA volume at the local host (near site). If no
–l
option is specified then this option re-synchronizes a
cascading CA volume at the remote host (far site).
The target CA volume must be a P-VOL and the
–swap [s | p] option cannot be specified.
The MU# specifies the cascading mirror descriptor for
CA-Journal.
–FBC [MU#] Used to forcibly resync a BC pair whose P-VOL is a
CA S-VOL. If the –l option is specified, this option
resynchronizes a cascading BC volume on a local host
(near site). If no –l option is specified, this option
resynchronizes a cascading BC volume on a remote
host (far site).