HP XP RAID Manager Software - Manual (Page 187)

187
–m marker Used to specify the Q-marker, the async-CA sequence #
of the main control unit (MCU) P-VOL. If RM gets the
Q-marker from the –nowait option, then it can confirm
the completion of asynchronous transfer to that point,
by using pairsysncwait with that Q-marker.
If a Q-marker is not specified, RM uses the latest
sequence # at the time pairsysncwait is executed. It is
also possible to wait for completion from the S-VOL
side.
Q-marker format:
–nowait Used to get the latest sequence # of the MCU P-VOL
and CTGID without waiting.
When this option is specified, the latest sequence # of
MCU P-VOL is reported immediately, and the
–t
timeout options are ignored.
–q Terminates interactive mode and exits this command.
–t timeout Used to specify the timeout value to wait for the
completion of the remote control unit (RCU) disk fast
write (DFW) cache area. It is expressed in units of
multiples of 100ms. The MCU gets the latest sequence
# from the RCU at regular intervals.
–z Makes this command enter interactive mode.
–zx (Not for use with MPE/iX and OpenVMS) Prevents you
from using RM in interactive mode. This option
terminates interactive mode upon RM shutdown.
The sequence # of P-VOL
The incarnation # of PAIR volume
iissssssss