HP XP RAID Manager Software - Manual (Page 209)

209
–find [op] [MU#] Used to execute the specified [op] using a raw device
file provided by STDIN. See next entries.
–find sync [MU#] [–g name]
Flushes the system buffer of the logical drive
corresponding to a –g name (dev_group) in the RM
configuration file. The dev_group name is provided via
STDIN through the KEY WORD($Volume,$LETALL,
$Physical).
The –g name option is used to specify the name to be
used for dev_group in the horcm.conf file. If this
option is not specified, then the system buffers
associated with all groups for the local instance are
flushed.
If the logical drive corresponding to a –g name is not
open for any application, then the logical drive system
buffer is flushed and the drive is unmounted.
If the logical drive corresponding to a –g name is open
for an application, then the logical drive system buffer
is only flushed.
This option allows the system buffer to be flushed
before a pairsplit without unmounting the PVOL (open
state).
–find verify [MU#]
Used to verify the relationship between a Group in the
configuration definition file and a Device_File
registered to the LDEV map tables (based on the raw
device file name provided via STDIN).
This option also allows you to use the –fx option to
display the LDEV numbers in hexadecimal format. You
can also use this in conjunction with the –fd option.
This option will be affected by the command execution
environment (HORCC_MRCF).