HP XP RAID Manager Software - Manual (Page 377)

Porting notice for MPE/iX 377
You cannot remove the ‘/tmp/curlog’ directory even if you use the mv
/users/HORCM/log*/curlog /tmp
command.
MPE/iX startup procedures
Make a JOB control file
The following is an example of JOB control file named JRAIDMR0 (
HORCMINST=0 ).
!job jraidmr0, manager.sys;pri=cs
!setvar TZ "PST8PDT"
!xeq sh.hpbin.sys '/HORCM/usr/bin/horcmstart.sh 0'
!eoj
Make the device special files and check the LDEV configuration
You are able to use -inst option that is used to make a special file as
“/dev/ldev*”
from “LDEV-” of the dstat command for the SCSI pass-thru
driver.
shell/iX> callci dstat | ./inqraid -inst -CLI
Note: LDEV user here refers to the MPE/iX term.
Describe the command device on /etc/horcm*.conf
HORCM_MON
#ip_address service poll(10ms) timeout(10ms)
NONE horcm 1000 3000
HORCM_CMD
#dev_name dev_name dev_name
/dev/ldev103
DEVICE_FILE PORT SERIAL LDEV CTG C/B/12 SSID R:Group PRODUCT_ID
ldev100 CL1-L 35013 17 - s/s/ss 0004 5:01-01 OPEN-3
ldev101 CL1-L 35013 18 - s/s/ss 0004 5:01-01 OPEN-3
ldev102 CL1-L 35013 19 - s/s/ss 0004 5:01-01 OPEN-3
ldev103 CL1-L 35013 35 - - - - OPEN-3-CM