KYORITSU 6300 Instruction Manual - Manual (Page 86)

MODEL6300
7. 6
MODEL6300 Section 7 Integration value measurement
Section
7
NOTE:
* mark is displayed on the W and DEMAND range, while the
instrument is performing measurement.
* The start time and date should be set after the current time in such a way
to give enough time to the user to complete all settings before the survey
starts.
* When the start time and date are set before the current time, measurement
starts immediately upon pressing the
START/STOP key.
* If the preset start time and date come after the preset stop time and date,
the survey cannot be done.
* Even if the start and stop time have been preset and the instrument is in
standby mode, pressing the
START/STOP key at least 2 sec. releases the
stand-by mode and start a survey in Manual mode. This renders the
start/ stop time and date settings ineffective.
Then , , (or ) marks disappear and the LED status
indicator goes off.
‣ ‧ • ⁈ ‥ • •⁈ • •⁈ ‣ ⁂․⁉ ‣⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥⁂… ⁉
‧ ″ ‣• ″ ․ •″ ‧• ″ ‣ • • ″ ․ • •″ ‧ • • ″ ‣ • • • ″
‣‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂․⁉ ‣ ⁂‥ ⁉ ‥ ⁂‥⁉ ‥ ⁂… ⁉
‧ ″ ‣ • ″ ․ • ″ ‧ • ″ ‣ • • ″ ․ • • ″ ‧ •• ″ ‣ • • • ″