KYORITSU 6300 Instruction Manual - Manual (Page 71)

6. 11
MODEL6300
Section 6 Instantaneous value measurement MODEL6300
NOTE
* “f” can be customized only at the upper row, and “In” can be displayed only at
the middle row. (when wiring configuration is three-phase 4-wire)
* On pressing the
ENTER key whilst on Screen 3, the instrument will display
Screen 1-A custom mode.
* Customizing cannot be done during an integration/ demand measurement
whilst a survey is underway. This applies also for integration/demand stand by
mode.
* After system reset, start-up screen appears.
* Pressing the
ESC key during custom display mode restores the original
displayed parameters.
‣‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥ ⁂… ⁉
‧ ″ ‣ •″ ․ • ″ ‧ • ″ ‣ •• ″ ․• • ″ ‧ • •″ ‣ • • • ″
‣‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥ ⁂… ⁉
‧ ″ ‣ •″ ․ • ″ ‧ • ″ ‣ •• ″ ․• • ″ ‧ • •″ ‣ • • • ″
‣‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂․⁉ ‣ ⁂‥ ⁉ ‥ ⁂‥⁉ ‥ ⁂… ⁉
‧ ″ ‣ • ″ ․ • ″ ‧ • ″ ‣ • • ″ ․ • • ″ ‧ •• ″ ‣ • • • ″
‣‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂․⁉ ‣ ⁂‥ ⁉ ‥ ⁂‥⁉ ‥ ⁂… ⁉
‧ ″ ‣ • ″ ․ • ″ ‧ • ″ ‣ • • ″ ․ • • ″ ‧ •• ″ ‣ • • • ″