KYORITSU 6300 Instruction Manual - Manual (Page 80)

MODEL6300
6. 20
MODEL6300 Section 6 Instantaneous value measurement
Section
6
‣ ‧ • ⁈ ‣ ‧ • ⁈ ‥ • • ‥ • •⁈ • • • •⁈ ‣ ⁂․⁉ ‣⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥⁂… ⁉
‧ ″ ‧ ″ ‣• ″ ․ •″ ‧• ″ ‣ • • ″ ‣ • • ″ ․ • • ․ • •″ ‧ • • ″ ‧ • • ″ ‣ • • • ″ ‣ • • • ″
< mark>
When “ ” appears for over-range indication for any of A1, A2 and A3,
this is displayed on the LCD. In this case, mark appears on all
measurement screens on the
W position.
Over-range indication Over-range indication
for voltage value for current value
Ɣ Bar indication
The calculations and measurements performed by this instrument are based
on the voltage and frequency of V1. If the value of V1 is less than 5% of the
chosen range or if the frequency is not within 40 ~ 70Hz, all the parameters
(except for current ) cannot be computed and thus displayed. In such a case,
the numerical digits will be replaced by a bar indication (“- - - -”) as shown:
NOTE:
* or mark is displayed every measurement screen while a
measurement is performed on
Wh or DEMAND range.
‣ ‧ • ⁈ ‣ ‧ • ⁈ ‥ • ‥ •• ⁈ • ⁈ • •• ⁈ • ⁈ ‣ ⁂ ‣ ⁂․ ⁉ ․ ⁉ ‣ ⁂ ‣ ⁂‥ ⁉ ‥ ⁉ ‥ ⁂ ‥ ⁂‥ ⁉ ‥ ⁉ ‥ ⁂ ‥ ⁂… ⁉ … ⁉
‧ ″ ‧ ″ ‣ • ″ ‣ • ″ ․ •″ ‧ • ″ ‧ • ″ ‣• • ″ • • ″ ․ •• ″ ‧ •• ″ ‣• • • ″ • • • ″
‣ ‧ • ⁈ ‥ •• •• ⁈ •• •• ⁈ ‣ ⁂․ ⁂․ ⁉ ‣ ⁂‥ ⁂‥ ⁉ ‥ ⁂‥ ⁂‥ ⁉ ‥ ⁂… ⁂… ⁉
‧ ″ ‧ ″ ‣ • ″ ‣ • ″ ․ •″ ‧ • ″ ‧ • ″ ‣• • ″ • • ″ ․ •• ″ ‧ •• ″ ‣• • • ″ • • • ″
indication
mark mark