KYORITSU 6300 Instruction Manual - Manual (Page 110)

MODEL6300
8. 12
MODEL6300 Section 8 Demand value measurement
Section
8
‣ ‧ • ‣ ‧ • ⁈ ‥ • • ‥ • • ⁈ • • ⁈ ‣ ⁂ ․ ⁉ ‣ ⁂ ‥ ⁉ ‥ ⁂‥ ⁉ ‥ ⁂… ⁉
‧ ″ ‧ ″ ‣ • ″ ․ • ″ ‧ • ″ ‣ • • ″ • • ″ ․ • ․ • • ″ • ″ ‧ • • ″ • • ″ ‣ • • ‣ • • • ″ • ″
8-4 Survey closure
There are two methods for closing a survey.
(1) Manual operation
Pressing
START/STOP key on DEMAND range for at least 2 sec. stops
measurement. This action also stops the measurement started automatically
at a preset date and time.
(2) Automatic operation (specifying the time and date)
Preset the stop time and date on
SET UP range (“Setting 15”).
Ɣ To stop measurement manually
* Pressing
START/STOP key on DEMAND range for at least 2 sec. stops
the measurement. When it stops, , (in case data is to be
saved to CF card) marks disappear and the LED status indicator goes off.
Ɣ To stop measurement automatically at the preset time and date
Set the stop time and date on SET UP range. (“Setting 15”)
This method is available only when the measurement is started at the preset
time and date. When the preset stop time and date has been reached,
, (in case data to be saved to CF card) marks disappear and
LED status indicator goes off. The survey is then closed.
When measurement stops manually or automatically, mark appears for
1 sec. thus closing the file opened at the start of the survey.
NOTE
* When data is saved to the internal memory, mark stays on even after
survey closure . (indicating that a file exists in the internal memory.)