KYORITSU 6300 Instruction Manual - Manual (Page 34)

MODEL6300
4. 8
MODEL6300 Section 4 Setting
Section
4
‣ ‧• ⁈ ‥ •• ⁈ ••⁈ ‣ ⁂․ ⁉ ‣⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥⁂ …⁉
‧″ ‣• ″ ․• ″ ‧•″ ‣• •″ ․• •″ ‧•• ″ ‣ •• •″
‣ ‧• ‧• ⁈ ‥ ••⁈ ••⁈ • • •⁈ •⁈ ‣⁂ ‣⁂ ․⁉ ․⁉ ‣⁂ ‣⁂ ‥⁉ ‥⁉ ‥ ⁂‥ ⁉ ‥ ⁂…⁉ …⁉
‧″ ‧″ ‣ •″ •″ ․• ․• ″ ‧ •″ •″ ‣ ••″ ••″ ․ ••″ ••″ ‧• ‧• •″ •″ ‣•• ‣•• •″ •″
4-3-4 “Setting 04” Clamp sensor
Current range (“Setting 03”) varies depending on the selected
clamp sensor.
Clamp sensor Current range (“Setting 03”)
50A (M-8128) 5A / 10A / 20A / 50A
100A (M-8127) 10A / 20A / 50A / 100A
200A (M-8126) 20A / 50A / 100A / 200A
500A (M-8125) 50A / 100A / 200A / 500A
1000A (M-8124) 100A / 200A / 500A / 1000A
3000A 1000A / 3000A
Default value 500A
* Using the Cursor key whilst in the selection screen, select “Setting 04”.
* Press the ENTER key to enter setting change mode.
* Previous setting (or default value) flickers. Select the desired clamp sensor
with the
Cursor key, and then press the ENTER key.
NOTE
* When the clamp sensor (“Setting 04”) is changed, the current range will
also change accordingly.
* When the Clamp sensor in use is different from the setting for the sensor
made at “Setting 04”, readings obtained are not correct.
* The whole range of Clamp sensors is not yet available. For more information,
please contact your local KYORITSU distributor.
50A 100A
500A
200A
1000A 3000A
or
or