KYORITSU 6300 Instruction Manual - Manual (Page 47)

4. 21
MODEL6300
Section 4 Setting MODEL6300
‣ ‧ ‣ ‧• ⁈ • ⁈ ‥ • ‥ •• ⁈ • ⁈ • •• ⁈ • ⁈ ‣⁂ ․⁉ ‣ ⁂ ‣ ⁂‥ ⁉ ‥ ⁉ ‥⁂ ‥⁉ ‥⁂ …⁉
‧″ ‧″ ‣• ‣• ″ ․ •″ •″ ‧• ‧• ″ ‣ •• •• ″ ․ •• •• ″ ‧ •• •• ″ ‣ •• •• •″ •″
4-3-17 “Setting 17” Demand inspection cycle
For further information on Demand inspection cycle, refer to
“Section 8: Demand measurement” in this manual.
Depending on the demand interval chosen, at “Setting 13”, the inspection
cycle can be set as follows.
Demand interval
(“Setting 13”)
Inspection cycle
1 sec./ 2 sec./ 5 sec. Cannot be set.
10 sec. 1 sec./ 2 sec./ 5 sec.
15 sec. 2 sec./ 5 sec./ 10 sec.
20 sec. 5 sec./ 10 sec./ 15 sec.
30 sec. 10 sec./ 15 sec./ 20 sec.
1 min. 15 sec./ 20 sec./ 30 sec.
2 min. 20 sec./ 30 sec./ 1 min.
5 min. 30 sec./ 1 min./ 2 min.
10 min. 1 min./ 2 min./ 5min.
15 min. 2 min./ 5min./ 10 min.
20 min. 5min./ 10 min./ 15 min.
30 min. 10 min./ 15 min./ 20 min.
1 hour 15 min./ 20 min./ 30min.
Default value 10 min.
* Using the Cursor key whilst in the selection screen, select “Setting 17”.
* Press the ENTER key to enter setting change mode.
* Previous setting (or default value: 10 min.) flickers. Press the Cursor key,
and select the desired cycle. Then press the ENTER key.
‣ ‧•⁈ ‥• •⁈ •• ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥⁂ ‥⁉ ‥ ⁂…⁉
‧ ″ ‣ •″ ․ •″ ‧• ″ ‣•• ″ ․•• ″ ‧• •″ ‣• ••″
‣ ‧•⁈ ‥• •⁈ •• ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥⁂ ‥⁉ ‥ ⁂…⁉
‧ ″ ‣ •″ ․ •″ ‧• ″ ‣•• ″ ․•• ″ ‧• •″ ‣• ••″