KYORITSU 6300 Instruction Manual - Manual (Page 78)

MODEL6300
6. 18
MODEL6300 Section 6 Instantaneous value measurement
Section
6
Ɣ Active power P/ Reactive power Q/ Apparent power S
: P1/P2/P3, Q1/Q2/Q3, S1/S2/S3 , max 4 digits
: P, Q, S (total), max 5 digits
Power (*) x VT ratio x CT ratio x 120% Digit & Decimal point position
900 ~ 999.9 W/Var/VA 999.9 W/Var/VA
1k ~ 9.999k W/Var/VA 9.999 k W/Var/VA
10k ~ 99.99k W/Var/VA 99.99 k W/Var/VA
100k ~ 999.9k W/Var/VA 999.9 k W/Var/VA
1M ~ 9.999M W/Var/VA 9.999 M W/Var/VA
10M ~ 99.99M W/Var/VA 99.99 M W/Var/VA
100M ~ 999.9M W/Var/VA 999.9 M W/Var/VA
1G ~ 9.999G W/Var/VA 9.999 G W/Var/VA
10G ~ 99.99G W/Var/VA 99.99 G W/Var/VA
100G ~ 999.9G W/Var/VA 999.9 G W/Var/VA
1000G ~ 9999 G W/Var/VA 9999 G W/Var/VA
* The table shows values of power corresponding to each voltage and current
range.
Current range Voltage
range 5.000A 10.00A 20.00A 50.00A 100.0A 200.0A 500.0A 1000A
150.0V 750.0 1.500k 3.000k 7.500k 15.00k 30.00k 75.00k 150.0k
300.0V 1.500k 3.000k 6.000k 15.00k 30.00k 60.00k 150.0k 300.0k
600.0V 3.000k 6.000k 12.00k 30.00k 60.00k 120.0k 300.0k 600.0k
The above listed power values apply to single-phase 2-wire(1ch).The power
for a single-phase 2-wire(2ch)/single-phase 3-wire/ three-phase 3-wire system
will be twice that of the above values. Total power of the individual phases of a
single-phase 2-wire(3ch)/ three-phase 4-wire system will be three times that of
the above values.
Ɣ Power factor PF: PF (whole system), PF1/PF2/PF3 (each phase), 4 digits
Display range
-1.000 ~ 1.000 PF
Ɣ Frequency f: 3 digits
Display range
40.0 ~ 70.0 Hz
Ɣ Neutral current In (A) (only for three-phase 4-wire system): max 5 digits
Decimal point and the unit are same as for Current.