KYORITSU 6300 Instruction Manual - Manual (Page 41)

4. 15
MODEL6300
Section 4 Setting MODEL6300
‣ ‧•⁈ ‧•⁈ ‥• ‥• •⁈ •⁈ •• •• ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥⁂ ‥⁂ ‥⁉ ‥⁉ ‥ ⁂…⁉ …⁉
‧ ″ ‣ •″ •″ ․ •″ •″ ‧• ‧• ″ ‣•• ‣•• ″ ․•• ․•• ″ ‧• ‧• •″ •″ ‣• ‣• ••″ ••″
4-3-11 “Setting 11” Integration stop time and date
* Using the
Cursor key whilst in the selection screen, select “Setting 11”.
* Press the ENTER key to enter setting change mode.
* Time and date; Integration start time and date (“Setting 10”) plus Integration
interval (“Setting 09”), are displayed on the LCD, and second digits flicker.
* Change the time with the Cursor key, and then press the ENTER key.
For further details, refer to Integration start time and date (“Setting 10”) in
this manual.
NOTE
* The period between start and stop time of integration measurement can be
set to a shorter time than the integration interval(“Setting 09”). However, the
measured data will not be recorded.
‣ ‧•⁈ ‥• •⁈ •• ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥⁂ ‥⁉ ‥ ⁂…⁉
‧ ″ ‣ •″ ․ •″ ‧• ″ ‣•• ″ ․•• ″ ‧• •″ ‣• ••″
‣ ‧•⁈ ‥• •⁈ •• ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥⁂ ‥⁉ ‥ ⁂…⁉
‧ ″ ‣ •″ ․ •″ ‧• ″ ‣•• ″ ․•• ″ ‧• •″ ‣• ••″