KYORITSU 6300 Instruction Manual - Manual (Page 45)

4. 19
MODEL6300
Section 4 Setting MODEL6300
‣ ‧• ⁈ ‥ •• ⁈ ••⁈ ‣ ⁂․ ⁉ ‣⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥⁂ …⁉
‧″ ‣• ″ ․• ″ ‧•″ ‣• •″ ․• •″ ‧•• ″ ‣ •• •″
‣ ‧ ‣ ‧• ⁈ • ⁈ ‥ • ‥ •• ⁈ • ⁈ • •• ⁈ • ⁈ ‣⁂ ․⁉ ‣ ⁂ ‣ ⁂‥ ⁉ ‥ ⁉ ‥⁂ ‥⁉ ‥⁂ …⁉
‧″ ‧″ ‣• ‣• ″ ․ •″ •″ ‧• ‧• ″ ‣ •• •• ″ ․ •• •• ″ ‧ •• •• ″ ‣ •• •• •″ •″
4-3-15 “Setting 15” Demand stop time and date
.
* Using the Cursor key whilst in the selection screen, select “Setting 15”.
* Press the ENTER key to enter setting change mode.
* Time and date; demand start time and date (“Setting 14”) plus demand
interval (“Setting 13”) are displayed on the LCD, and the seconds digit will
flicker.
* Change the time with the Cursor key, and then press the ENTER key.
For further details, refer to demand start time and date (“Setting 14”) in this
manual.
NOTE
* The period between start and stop time of demand measurement can be
set to a shorter time than the demand interval(“Setting 13”). However, the
measured data will not be recorded.