KYORITSU 6300 Instruction Manual - Manual (Page 109)

‣ ‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂ ․ ⁉ ‣ ⁂ ‥ ⁉ ‥ ⁂ ‥ ⁉ ‥ ⁂ … ⁉
‧ ″ ‣ • ″ ․ • ″ ‧ • ″ ‣ • • ″ ․ • • ″ ‧ • • ″ ‣ • • • ″
‣ ‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥ ⁂… ⁉
‧ ″ ‣ • ″ ․ • ″ ‧ • ″ ‣ • • ″ ․ • • ″ ‧ • • ″ ‣ • • • ″
NOTE
* The start time and date should be set after the current time in such a way to
give enough time to the user to complete all settings before the survey
starts.
* When the start time and date are set before the current time, measurement
starts immediately upon pressing the
START/STOP key.
* When the preset start time and date come after the preset stop time and
date, measurement stops right after the start of measurement.
* Even if the start and stop time have been preset and the instrument is in
standby mode, pressing the
START/STOP key at least 2 sec. will release
the stand-by mode and start a survey in Manual mode. This renders the
start/ stop time and date settings ineffective.
Then , (or ) marks disappear and the LED status
indicator goes off.
8. 11
MODEL6300
Section 8 Demand value measurement MODEL6300