KYORITSU 6300 Instruction Manual - Manual (Page 8)

7
MODEL6300
Safety warnings MODEL6300
㩷
WARNING
Ɣ Never attempt to make any measurement if any abnormal conditions, such as
a broken cover or exposed metal parts are present on the Instrument,
Voltage test leads, Power cord and Clamp sensor.
Ɣ Ensure that the Current input terminal cover, USB connector cover and
CF card connector cover are closed when not in use during a measurement.
Ensure that the CF card connector cover screw is tightened.
Ɣ Do not install substitute parts or make any modification to the instrument.
Return the instrument to your local
KYORITSU distributor for repair or
re-calibration in case of suspected faulty operation.
Ɣ Ensure that the Power cord, Voltage test leads and Clamp sensor are firmly
inserted into the terminal.
Ɣ Do not try to replace the batteries if the surface of the instrument is wet.
Ɣ Ensure that the Power cord, Voltage test leads and Clamp sensor are removed
from the instrument, and that the instrument is switched off when opening the
Battery cover for battery replacement.
㩷
CAUTION
Ɣ Always set the Function switch to the appropriate position before making
measurement.
Ɣ Set the Function switch to the “OFF” position after use and remove the Power
cord, Voltage test leads and Clamp sensors. Remove the batteries if the
instrument is to be stored and will not be in use for a long period.
Ɣ Do not expose the instrument to direct sunlight, high temperatures, humidity
or dew.
Ɣ Use a damp cloth with neutral detergent for cleaning the instrument.
Do not use abrasives or solvents.
Ɣ Do not store the instrument if it is wet.
Carefully read and follow the instructions: DANGER, WARNING,
CAUTION and NOTE, described in each section.
The following symbols are used in this manual:
User must refer to the explanations in the instruction manual.
Instrument with double or reinforced insulation, Class II insulation
~
AC
(Functional) Earth terminal