KYORITSU 6300 Instruction Manual - Manual (Page 108)

MODEL6300
8. 10
MODEL6300 Section 8 Demand value measurement
Section
8
‣ ‧ • ⁈ ‧ • ⁈ ‥ • ‥ • • ⁈ • ⁈ • • • • ⁈ ‣ ⁂ ․ ⁉ ‣ ⁂ ‥ ⁉ ‥ ⁂ ‥ ⁉ ‥ ⁂ … ⁉
‧ ″ ‧ ″ ‣ • ″ ‣ • ″ ․ • ″ ․ • ″ ‧ • ″ ‧ • ″ ‣ • ‣ • • ″ • ″ ․ • • ″ ․ • • ″ ‧ • • ″ • • ″ ‣ • ‣ • • • ″ • • ″
‣ ‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥ ⁂… ⁉
‧ ″ ‣ • ″ ․ • ″ ‧ • ″ ‣ • • ″ ․ • • ″ ‧ • • ″ ‣ • • • ″
Ɣ To start measurement automatically at the preset time and date
* Set the start time and date on
SET UP range (“Setting 14”).
* Then set the Function switch to DEMAND range, and press the
START/STOP key.
* File number screen is displayed for about 2 sec. (a file is opened), followed
by the measurement screen. The instrument goes into stand-by mode
for measurement. LED status indicator and mark flicker while the
instrument is in stand-by mode.
File number screen
(displayed for about 2 sec.)
Measurement screen
When data is saved to the CF card, mark;
when data is saved to the internal memory, mark :
appears on the File number screen and measurement screen.
(See “Setting19”.)
* Measurement starts at the preset time and date, and the mark and
the LED status indicator stop flickering and remain on for the duration of
the survey.
NOTE
* The mark , which indicates demand measurement or stand-by mode,
is also displayed if the Function switch is changed to
W range or Wh
range.
LED status indicator
flicker