KROHNE Summit 8800 Vol 2 - Manual (Page 51)

51 www.krohne.com
08/2013 - MA SUMMIT 8800 Vol2 R02 en
SUMMIT 8800 HARDWARE DETAILS 05
5. Hardware
e
This paragraph provides instructions on how to configure the I/O boards for the types of sig-
nals to be utilised by the field instruments to the SUMMIT 8800. (For details on the boards, see
volume 1)
Figure 23 Configurator I/O board setup
The SUMMIT 8800, I/O and communication boards can be configured on-line or off-line.
When on-line, the slots will be populated as the current configuration information will be polled
by the software.
When setting up in off-line mode, it is important to select the right I/O and communication board
in the corresponding slot.
To configure a board, select the board type as per Figure 23, right hand side. This is done by
clicking on the pull down menu and selecting the required/installed board in the relevant posi-
tion.
Figure 24 I/O and communication board selected
Figure 24 shows an example where each slot is occupied different boards.
Directly below the Board Type is a Warning tab. Here can be configured what action should be
taken if, during normal operation, a wrong, missing or faulty board is found. This can be a warn-
ing, a fault or no action at all.