KROHNE Summit 8800 Vol 2 - Manual (Page 140)

140 www.krohne.com 08/2013 - MA SUMMIT 8800 Vol2 R02 en
SUMMIT 8800 PROVER 10
Figure 143 Prover options: general, proving points
Settings
Depending on the prover type, additional settings are needed as follows:
Figure 144 Prover options: general settings, uni-directional prover
Ball release time Release command time to valve
Maximum loop time Allowable time for sphere to travel a complete loop – chamber to chamber
Maximum chamber time Time for sphere to travel past last detector switch to home chamber
Pump check delay time Pump running signal check status wait delay
Figure 145 Prover options: general settings, bi-directional prover
Maximum loop time Allowable time for sphere to travel a complete loop – chamber to chamber
Maximum chamber time Time for sphere to travel past last detector switch to home chamber
Figure 146 Prover options: general settings, small volume prover
Maximum forward time Piston travel time from start to end position
Maximum reverse time Piston start position recovery time
Home detection The use of a home detector switch – yes or no
Plenum deviation limit Maximum deviations between calculated and measure plenumm pressure
Plenum deviation time Deviation time allowable for limit