Teledyne LeCroy Summit T3-16 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 67)

Summit T3‐16 PCI Express Multi‐Lane Protocol Analyzer User Manual 55
Trace Filename and Path Teledyne LeCroy
.
Figure 5.2: Switch to Simple Mode Button
5.5 Trace Filename and Path
The Trace Filename and Path button sets the path and CATC Trace name for the recording.
It allows you to change the default file name and path for the recorded CATC Trace file.
The pre‐defined name is data.pex. See
Figure 5.1 on page 54: 1A .
1. Select the Recording File Name button.
2. The Specify Trace File Name dialog opens to navigate to the directory you want.
3. Enter the new file name in the File name field.
4. Click the Save button.
This action does not do any immediate save operation. It just changes the default
name and uses it in subsequent recordings.
5.6 Saving and Loading Previously Saved Recording Options
You can save a recording or load previously saved recordings. In the general tab the
following Save options are available (see
Figure 5.1 on page 54 ).