Teledyne LeCroy Summit T3-16 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 191)

Summit T3‐16 PCI Express Multi‐Lane Protocol Analyzer User Manual 179
Chapter 10
Reports and Tools
Reports assist you in analyzing traffic recorded by the Analyzer. The available reports are:
 File Information: To view general information about the CATC Trace file.
 Error Summary: To view a count of errors in a CATC Trace file.
 Traffic Summary: To view a summary of protocol‐related information in the
CATC Trace file summary information about a selected group of items in the
CATC Trace file (such as a count of particular frame or packet types).
 Bus Utilization: To display information on bandwidth usage for the transmit and
receive channels.
 Link Tracker: Displays a detailed chronological view of events.
 Data Flow: Shows marker, packet, direction, type, length, address, payload, hand‐
shake, and timestamp information.
 Trace Navigator: Navigates within the CATC Trace to view the location of errors
and triggers, narrow the range of traffic on display, and jump to any point in the
CATC Trace.
 Detail View: Shows the detail view of the selected packet.
 LTSSM Flow Graph: Shows a state diagram of bus activity.
 Packet Header: Shows packet header information.
 Packet Data: Shows packet or transaction payload.
 Configuration Space: Displays a Configuration Space.
 Metrics: Measures key operating parameters
 Real Time Statistics: To display statistical information for the channels.
 Memory I/O Space Editor: Displays the Memory I/O Space Editor dialog.
 TC to VC Mapping: To display how Traffic Classes are mapped to Virtual Channels
(to simplify navigation) and how the CATC Trace display was changed (for exam‐
ple, in Split Transactions).
 Timing Calculations: To view timing measured between two events set within the
CATC Trace file.
 PCIe SSD base Mapping: Displays the PCIe SSD Base Address dialog.
 Run Verification Scripts: Allows you to check errors, link transactions, split trans‐
actions, metrics, ordered sets, replays, DLLPs, and TLPs.
Reports are available from the Report menu and buttons on the Tool bar. Tools are
available from the Tools menu.