Teledyne LeCroy Summit T3-16 PCIe Multi-lane Protocol Analyzer User Manual User Manual
Page 21
Summit T3‐16 PCI Express Multi‐Lane Protocol Analyzer User Manual
9
Setting Up the Summit T3‐16 Analyzer using an Ethernet Connection
Teledyne LeCroy
Click Finish when you see the message that says “Windows has finished installing
the software that your new hardware requires” and the file has been installed in
your host machine.
3.3
Setting Up the Summit T3-16 Analyzer using an Ethernet
Connection
1. Connect the Analyzer to a 100‐volt to 240‐volt, 50 Hz to 60 Hz, 120 W power outlet
using the provided power cord.
2. Connect the Summit T3 Analyzer to the network. The Ethernet port is on the front of
the Analyzer.
Note:
“Setting Up the Summit T3‐16 Analyzer using a USB Connection” on
.
3. Turn on the front power switch.
Note:
At power‐on, the Analyzer initializes itself in approximately five seconds and performs an
exhaustive self‐diagnostic that lasts about forty seconds. The results are reflected by messages
on the Summit T3‐16 LCD display. If the LCD display indicates failure, call Teledyne
LeCroy Customer Support for assistance.
4. After you have installed the PETracer application software, perform the following
procedure to connect to a Summit T3‐16 analyzer in the local network.
Select the Setup > All connected devices… menu in the PETracer application to
display the Analyzer Devices dialog.
Figure 3.3: Analyzer Devices Dialog