Teledyne LeCroy Summit T3-16 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 24)

Teledyne LeCroy Analyzer Network
12 Summit T3‐16 PCI Express Multi‐Lane Protocol Analyzer User Manual
Click the Recent button to display a list of recently added devices (up to 15) and quickly
add a recently used device.
Click the Ping button to ping a device as a network node (prompting an error message if
no response). Ping also allows PETracer to detect a device type before actually connecting
to the device.
If the "Ping" feature discovers that the device is already connected and "locked" then it
will inform the user and provide information about who locked the device.
Click Setup ‐> All Connected Devices to display the Analyzer Devices dialog .
If software fails to connect to a manually added device, a message displays notifying the
user about the connection failure. The user is given the option to keep the failed device in
the device list, in this case PETracer displays a "Failed to connect" status message in grey.
Square brackets for IP addresses are used for manually added devices to easily distinguish
them from auto‐discovered devices.
Figure 3.7: Add Ethernet Attached Devices Dialog
3.5 Analyzer Network
For Ethernet, to display the host machines and analyzers on the local network, select 
Setup > Analyzer Network to display the Analyzer Network dialog (see
Figure 3.8 on
page 13 ).
The Analyzer must be turned on before it appears in the list.