Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 75)

LabMaster 10 Zi Oscilloscopes
68 LM10Zi-GSM-E Rev A

Label - Enables you to attach identifying labels to your
waveforms. The labels are preserved when the waveform is
saved as a LabNotebook entry and when saved to file.

Probe Cal - Cable Deskew - Opens the Probes Cal. dialog where
various Gain, Offset, Skew, Source, and Advanced controls are
available for probe signal calibration.
Another example is seen in the buttons appearing at the bottom of the
Measure Px dialogs. The button may be selected in order to display the
functions named on the buttons (sometimes labeled as Actions):
Shortcut buttons on the Fx dialog.
Using these buttons allow you to remain in the Measure dialog while
setting up a Math trace on a parameter measurement.
Message Bar
At the bottom of the oscilloscope display is a narrow message bar. The
current date and time are displayed at the far right. Status, error, or
other messages are also shown in this area.