Teledyne LeCroy LabMaster 10Zi Getting Started Manual User Manual
Page 200
Getting Started Manual
LM10Zi-GSM-E Rev A
193
Use the Auxiliary Output to send the following signals to other
instruments:
Trigger Enabled - This function can be used as a gating
function to trigger another instrument when the oscilloscope is
ready.
Trigger Out - This function can be used to trigger an
external oscilloscope.
Pass/Fail - Allows you to set a pulse duration (which
varies based on your specific model, refer to datasheet
specifications at www.teledynelecroy.com for details); generates
a pulse when pass/fail testing is active and conditions are met.
Fast Edge - Some models provide this signal output used
to deskew multiple channels. The Fast Edge connection varies
based on model and is either SMA or BNC.
C
ALIBRATION
O
UTPUT
S
IGNALS
A calibration signal can be output from the Probe Calibration Hook on
the front of the oscilloscope. The following Calibration Output Signals
are available for use:
Square Wave - You can set a Frequency value (varied
based on your specific model, refer to datasheet specifications at
www.teledynelecroy.com for details).
DC Level - This is a reference level.
Off - This function turns off the Auxiliary Output signal.