Teledyne LeCroy LabMaster 10Zi Getting Started Manual User Manual
Page 60
Getting Started Manual
LM10Zi-GSM-E Rev A
53
Specific Menu Bar functions are referenced using arrow-separated path
descriptions. For example, the Save Setup function is referenced as File
→ Save Setup....
NOTE: For common oscilloscope operations, you don't need to use the
top menu bar (since you can access most dialogs from the Front Panel
or from the Descriptor Labels). However, it is the only way to access
setup or other dialogs for Display Setup, Save or Recall Waveform,
Save or Recall Setups, Print Setup, Vertical (Channel), Horizontal, or
Trigger Status, Memory (Reference Waveform) Setup, Pass/Fail Setup,
or Utilities and Preferences Setup....
Quick Access Toolbar
The Quick Access toolbar is located on the right side of the menu bar.
You can use these toolbar buttons to quickly access Trigger, Processing
and Undo functionality.
Q
UICK
A
CCESS
T
RIGGER
F
UNCTIONS
Auto - Press to turn on Auto Trigger mode, which triggers the
oscilloscope after a time-out, even if the trigger conditions are
not met.
Normal - Press to turn on Normal Trigger mode, which triggers
the oscilloscope each time a signal is present that meets the
conditions set for the type of trigger selected.
Single - Press to turn on Single Trigger mode for the selected
channel, which arms the oscilloscope to trigger once (single-shot
acquisition) when the input signal meets the trigger conditions
set for the type of trigger selected. If the oscilloscope is already
armed, it forces a trigger.
Stop - Press to prevent the oscilloscope from triggering on a
signal. If you boot up the instrument with the trigger in Stop
mode, the message "no trace available" is shown.