Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 14)

Getting Started Manual
LM10Zi-GSM-E Rev A 7
CAUTION Hibernate mode is not supported by the Power button.
Therefore, Windows® Power Options must not be changed from the
default Never setting to System Standby or System Hibernate modes.
CAUTION Always use the Power Switch or File → Shutdown
command in the software to properly shut down your instrument.
Never substitute this practice by pulling the instrument power cord
from the socket or shutting down a connected power strip.
Oscilloscope Calibration
The recommended calibration interval is one year. Calibration should be
performed by qualified personnel only.
Cleaning
Clean only the exterior of the instrument, using a damp, soft cloth. Do
not use harsh chemicals or abrasive elements. Under no circumstances
allow moisture to penetrate the instrument.
Avoid electrical shock hazard by unplugging the power cord from the AC
outlet before cleaning.
WARNING There are no operator serviceable parts inside. Do not
remove covers. Refer servicing to qualified personnel.
Lifting and Moving
Components housed in the OC910 oscilloscope cart may be wheeled
from place to place as a unit. If components must be removed from the
cart or other mounting, disconnect and move components separately.
We recommend using two persons, one at each end, to lift and stack
components.