Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 181)

LabMaster 10 Zi Oscilloscopes
174 LM10Zi-GSM-E Rev A
Your setup file is then saved to the D:\Internal Setups location on your
instrument and the current date/time is shown above the SetupX data
entry control.
S
AVE
S
ETUP
(
S
) D
IRECTLY TO A
F
ILE
1. Touch the File button on the Save To section on the dialog.
2. Touch inside the Save files in directory control and provide a
path to the destination folder.
OR
Touch Browse to navigate to the destination folder.
3. Touch the Save Now button.
Recalling Oscilloscope Setup(s)
Access the Recall Setup... dialog by either selecting File → Recall
Setup... from the menu bar or clicking the Recall Instrument Setup
button on the main Save/Recall dialog. Use one of the following two
methods to save setup(s).
R
ECALL
I
NTERNAL
S
ETUP
(
S
)
FROM
Y
OUR
I
NSTRUMENT
Touch one of the six Recall buttons in the Recall From Internal Setup...
section of the dialog.
Each Recall button is labeled with a corresponding setup storage slot. If
a setup is stored, SetupX is shown along with the date/time of the save,
otherwise, the slot is labeled Empty.
R
ECALL
S
ETUP
(
S
) D
IRECTLY FROM A
F
ILE
Recall your setup(s) directly from a file by using controls on the Recall
From File section on the right side of the dialog. Touch inside the Recall
panel from file data entry control and provide a path to the destination
folder. Or touch Browse to navigate to the destination folder. Finally,
touch the Recall Now button.