Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 213)

LabMaster 10 Zi Oscilloscopes
206 LM10Zi-GSM-E Rev A
EN 61000-4-5:2006 Power line Surge, 1 kV AC Mains, L-N, L-PE, N-PE
4
EN 61000-4-6:2007 RF Conducted Electromagnetic Field, 3 Vrms, 0.15
MHz - 80 MHz
4
EN 61000-4-11:2004 Mains Dips and Interruptions, 0%/1 cycle, 70%/25
cycles, 0%/250 cycles
4 5
1
To ensure compliance with all applicable EMC standards, high quality
shielded interface cables should be used.
2
Emissions which exceed the levels required by this standard may occur
when the oscilloscope is connected to a test object.
3
This product is intended for use in nonresidential areas only. Use in
residential areas may cause electromagnetic interference.
4
Meets Performance Criteria "B" limits of the respective standard:
during the disturbance, product undergoes a temporary degradation or
loss of function or performance which is self-recoverable.
5
Performance Criteria "C" applied for 70%/25 cycle voltage dips and for
0%/250 cycle voltage interruption test levels per EN61000-4-11.
European Contact:
Teledyne LeCroy Europe GmbH
Waldhofer Str 104
D-69123 Heidelberg
Germany
Tel: (49) 6221 82700
A
USTALIA
& N
EW
Z
EALAND
D
ECLARATION OF
C
ONFORMITY
– EMC
Oscilloscope complies with the EMC provision of the Radio
Communications Act per the following standards, in accordance with
requirements imposed by Australian Communication and Media
Authority (ACMA):
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in
accordance with EN61326-1:2006 and EN61326-2-1:2006.