Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 125)

LabMaster 10 Zi Oscilloscopes
118 LM10Zi-GSM-E Rev A
1. Touch the Dual button on the Display Mode section of the
Display dialog.
2. Touch inside the Grid control on the Grid Mode section of the
dialog. The Select Grid pop-up is shown.
3. Touch the Dual Display category and choose from Single/Single,
Dual/Dual, and Quad/Quad options.
Your grid selection is now shown on both displays.
Persistence
Persistence Overview
The Persistence feature helps you display your waveform and reveal its
idiosyncrasies or anomalies for a repetitive signal. Use Persistence to
accumulate on-screen points from many acquisitions to see your signal
change over time. The instrument persistence modes show the most
frequent signal path in three-dimensional intensities of the same color,
or graded in a spectrum of colors.
You can show persistence for up to eight inputs for any channel, math
function, or memory location (M1 to M4).
Persistence Setup
Choose Display → Persistence Setup... from the menu bar, then touch
the Persistence On checkbox.
Setup All Input Channels at Once
1. Touch the All Locked button.
2. Touch one of the Mode buttons.
3. Touch the Show last trace checkbox if you want the last trace
displayed.