Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 158)

Getting Started Manual
LM10Zi-GSM-E Rev A 151
Your test data is shown on the Table display area shown in the previous
screen-shot.
Pass/Fail Setup on Qx Dialogs
The Qx dialog contains several controls for specifying your Pass/Fail
conditions.
M
AIN
Q
X
D
IALOG
C
ONTROLS
Use the Source1 control to specify the waveform you'll use for your
Condition.
Set your Pass/Fail condition by touching the Condition control on the
corresponding Qx dialog. The Pass/Fail Condition pop-up is shown.