Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 53)

LabMaster 10 Zi Oscilloscopes
46 LM10Zi-GSM-E Rev A
Basic Controls
Front Panel Control Groupings
Miscellaneous Controls / WaveStream Indicator

Help - Opens the Teledyne LeCroy Online Assistant. If the second
monitor is installed, the online help opens on the second
monitor.

Default Setup - Resets the oscilloscope's settings to the default
configuration. Corresponds with screen menu selection: File →
Recall Setup → Recall Default Setup.... For a list of default
settings, see Save/Recall → Saving and Recalling Setups (on page
173).

Auto Setup - Opens the Auto Setup... flyout menu.
Press the Auto Setup... button on the flyout menu to perform a
full auto setup. Press a Channel Find Scale button on the flyout
menu to perform a quick auto setup for that channel only. Press
the A
UTO
S
ETUP
... front panel button twice to perform the last
selection from the Auto Setup... flyout menu (the default is to
perform a full auto setup).
If Auto Setup is run when no channels are turned on, all channels
are affected. When more than one channel is turned on, the first
channel with a signal applied to it is automatically set up for edge
triggering.