Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 154)

Getting Started Manual
LM10Zi-GSM-E Rev A 147
P
ERSISTENCE
S
IGMA
Using this math operator, you can enter a scale, measured in standard
deviations, by which to create a new waveform.
Viewing Trends
This procedure explains how to view the Trend of a math function or
measurement parameter applied to a waveform. A Trend shows... See
Track vs. Trend (on page 142) for a better understanding of the
information a Trend provides.
1. In the menu bar, touch Measure → Measure Setup....
2. Touch one of parameter tabs Px showing its corresponding
dialog.
3. Now, on the dialog, touch inside the Source1 data entry field and
select an input waveform from the pop-up menu.
4. Touch inside the Measure data entry field and select a parameter
from the pop-up menu.
5. Touch the Trend button at the bottom of the dialog.
Now, from the Math selection for Trend menu, select a math
function location Fx in which to store the Trend display. The
Trend is then shown along with its respective trace descriptor
label for the selected math function.
6. Touch the newly displayed Trend math function trace label to
change settings on the Trend dialog (located on the Trend tab at